System Setup
Selecting the menu option brings up the settings page. This page is used for configuring the system.
There are two system settings currently DCC System and Serial Port.
The DCC System is a drop down list of the DCC systems that are supported by this application (At time of writing this is currently only the NCE System and a Demo System.) The default for this setting is a Demo System that is used for mimicking a real DCC System for demo purposes.
The Serial Port is used for setting the serial port that the application will use to communicate with the DCC System. The default for this is /dev/ttyUSB0 for a windows installation this should be changed to COM1 etc depending on which port the DCC System is connected too.
Along with the system settings build information can also be found on this page. This shows various bits of information about when the application currently running was built.
